3M MV18-8FK Spade Connectors Bulk Scotchlok™ Standard

RVL2-5 BLUE

Ruichi

Insulated ring terminal RUICHI RVL2-5, 27 A, 16-14 AWG, blue, tinned brass is used when it is necessary to secure a wire in a screw connection. To install such type of terminals under the screw, it is necessary to fully unscrew it, so the installation time is relatively long. The ''O'' type terminal is a brass or copper plate with a hole that is placed on the screw. The bent edges of the plate form a cylinder into which the connected wire is inserted and crimped with special pliers or flat-nose pliers. Insulated ring terminals come in different widths and have corresponding hole diameters from M3 to M10.

QL100A 100A 1000V

Ruichi

RUICHI QL Diode Bridge, 100 A, 1000 V is an electrical device designed for converting, or in other words, rectifying alternating current into pulsating direct current. This rectification is called half-wave rectification and is performed using the Grez bridge circuit.

BNC-I

Ruichi

High frequency connector - a design intended for connecting various electronic devices to electrical circuits to achieve reliable transmission of high frequency signals. Losses at connection points are minimized. High frequency connectors can have regular or insulated housings. By the method of connection, they can be: with bayonet connection or with threaded connection.

TB253-1000-16

Ruichi

RUICHI TB253-1000-16 High-Power Fast-acting Thyristor, 1000 A, suitable for cooling devices: O143, O243, O343, OM103, OM104, PT53 package is designed for controlling and switching high currents. The thyristor can be seen as a kind of switch with two stable states: closed and open. The peculiarity of the thyristor''s operation is that if you connect a positive voltage to the anode relative to the cathode, it will not conduct current unlike a diode.

SSR-1 440V 60A (Z)D3 (3-32V)

Ruichi

Solid state relays are electronic devices with no moving mechanical parts, designed to switch high-power electrical circuits on and off using low voltage applied to control terminals.

BNCP-UHFJ

Ruichi

High-frequency connector - a design intended for connecting various electronic devices to electrical circuits for consistent reliable transmission of high-frequency signals. Losses are minimized at the connection points. High-frequency connectors may have standard or insulated housings. Depending on the connection method, they may be: bayonet type or threaded type.

3SSR 440V 10A (Z)A4 (90-280V)

Ruichi

Solid state relays are electronic devices with no moving mechanical parts, designed to switch high-power electrical circuits on and off using a low voltage applied to the control terminals.

SSR-1 440V 100A(Z)A4 (90-280V)

Ruichi

Solid state relay - electronic devices with no moving mechanical parts, designed to switch high-power electrical circuits on and off using low voltage supplied to the control terminals.

RVL2-4 BLUE

Ruichi

Insulated ring terminal RUICHI RVL2-4, 27 A, 16-14 AWG, blue, tinned brass is used when it is necessary to secure a wire in a screw connection. To install this type of terminal under a screw, the screw must be completely unscrewed, so the installation time is relatively long. The *O* type terminal is a brass or copper plate with a hole that fits onto the screw. The bent edges of the plate form a cylinder into which the connecting wire is inserted and crimped with special pliers or flat-nose pliers. Insulated ring terminals are available in various widths and have corresponding hole diameters for screws from M3 to M10.

BNCP-RCAP

Ruichi

-