Infineon Technologies IFX20002MBV33HTSA1 Linear Voltage Regulators Tape & Reel (TR) Fixed 3.3V

VP1-1 0.5A 250V

Ruichi

RUICHI cylindrical fuse VP1-1, 0.5 A, 250 V, -60...+100 °C, with a fusible element is used in compact power distribution devices to limit the effects of overload or short circuit.

1575R-A GPS 25DB MMCX-RP

Ruichi

RUICHI 1575R-A GPS 25db MMCX-RP embedded patch antenna, 5.4x15x15 mm, 1575.42 MHz, 25dBi, RHCP-circular, 50 Ohm, -40...+85 °C, internal mounting is a popular type of narrowband microwave antenna consisting of a flat metal petal fixed at some distance parallel to the ground plane. Typically, this design is enclosed in a plastic radiotransparent cover, both for protection against mechanical damage and for aesthetic reasons. Such antennas are simple to manufacture and can easily be modified to meet specific technical requirements. Patch antennas can be used as standalone devices or as radiators for building more efficient systems based on parabolic reflectors. Patch antennas are very similar to microstrip antennas, which are nothing more than patch antennas placed on a dielectric substrate.

DP-50C

Ruichi

The housing for D-SUB connectors is necessary for connecting to laptops, network equipment, digital projectors, HDMI televisions, and uninterruptible power supplies. Depending on the purpose, they can be made of plastic or metal.

DL-1DZ2KR 1A. 250V

Ruichi

Network filter is used in small electronic devices and measuring equipment. The filter for noise suppression is a separate complete unit, with a built-in standard three-pin socket, for connection to the device, a key switch, and isolated outputs, for connection to the power supply. There are mounting holes on the filter housing.

DL-8T1 8A. 250V

Ruichi

The network filter is used in compact electronic devices and measuring equipment. The filter for suppressing interference is a separate complete unit, with terminals for connection to the power supply. There are mounting holes on the filter housing.

BNC-SJ

Ruichi

High frequency connector - a design intended for connecting various electronic devices to electrical circuits for the reliable transmission of high frequency signals. Losses are minimized at the connection points. High frequency connectors can have standard or insulated housings. They can be bayonet or threaded connections.

ZCAT2035-0930A (GREY)

Ruichi

RUICHI ZCAT2035-0930A ferrite wire filter, grey, in case is designed to filter high-frequency interference and noise in conductors by increasing their inductance. They are installed on the cable on the side of the protected device 2-3 cm from the connector, on data transmission cables they can be installed from both ends of the cable.

AMMETER 500A (40X40)

Ruichi

Ammeter of the arrow type - an analog panel instrument designed for measuring direct current in a wide range. Installed in panels of various purposes.

SR25-1-1-12 ON WIRE

Ruichi

Rotary switch RUICHI SR25-1-1-12, 12 positions, 1 direction, 360° rotation angle, 0.3 A, 125 V, 500 mOhm, on wire, installed so that the increase of the adjustable values occurs when moving clockwise, and the decrease - when moving counterclockwise. This method of mounting the circuit reduces the possibility of errors. Rotary switches are the most common rotary switches. The number of handle positions corresponds to the number of contacts in the contact moving sector (contacts) located on the rotor.

DL-2DX31

Ruichi

The network filter is used in small electronic devices and measuring equipment. The filter for interference suppression is a separate complete unit with flexible insulated outputs of different colors for connection to power. There are mounting holes on the filter housing.